Kohler K-697 Guia De Instalacion página 7

Thin Wall Thick Wall
2x6
2x4
Plaster Guard
4-11/16" (11.9 cm) Max
3-3/16" (8.1 cm) Min
1. Install the Support Framing
NOTE: Shower only configuration is shown. Adjust the support as
needed for other configurations.
NOTE: Install a backer board behind the valve for installations on
2x6 studding only.
NOTE: A backer board will not fit behind the valve for installations
on 2x4 studding. Support the pipes directly above and/or below the
valve. This will also provide support for the valve.
NOTE: When installing the K-698 valve, use 1/2" nominal copper
tubing and fittings throughout this installation. Smaller diameter
piping upstream or downstream of the valve will reduce
performance of the valve.
NOTE: When installing the K-697 valve, use 3/4" nominal copper
tubing and fittings throughout this installation. Smaller diameter
piping upstream or downstream of the valve will reduce
performance of the valve.
Determine the desired configuration for your installation.
Kohler Co. 7 1066046-2-B