Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING VALVE ASSEMBLY
1.
Slide clamp ring over open side of tubing. (See Figure 2)
2. Insert valve assembly into bottom of flex tubing.
Ensure tubing covers entire flange. (See Figure 2)
3. Turn yellow handles to desired position.
4. Slide clamp ring down around tubing, covering
flange, and tighten screw with flat head screwdriver.
(See Figure 2)
Figure 2
SETTING UP CANVAS BAG
1.
Locate two steel rods with tail ends.
2. Insert end of chain link into the loop of rod.
(See Figure 3)
Figure 3
Steel Rod
3. Repeat step two with the other chain links.
PAGE 2 OF 6
INSTRUCTIONS CONTINUED
4. Insert one tail end through grommet at corner of
5. Insert the other tail end through grommet on the
6. Repeat step four and five with the second rod
7.
8. Place U-bolt over the center of rods "X" formation.
9. Re-insert plate then the two nuts on the U-bolt.
Chain
Link
10. Thread rope through both pulleys.
11. Raise bag to desired height and tie off rope.
1-800-295-5510
uline.com
canvas bag. Do not try to fit grommet into the loop.
(See Figure 4)
Figure 4
opposite side of canvas bag.
creating an "X" across the bag.
Locate U-bolt and remove the two nuts and plate
from the bolt.
Tighten nuts with pliers. (See Figure 5)
Plate
Nut
Figure 5
0521 IH-185
Publicidad
