Using The Seam Guides On The Needle Plate; Turning Square Corners; Variable Needle Position - ALFA 2622 Manual De Instrucciones

1
3
4

Using the Seam Guides on the Needle Plate

The seam guides on the needle plate help you to measure
seam width.
2

Turning Square Corners

To turn a square corner 1.6 cm (5/8") from the fabric edge.
When the fabric edge facing you lines up with the cornering
guide as illustrated, stop stitching and lower the needle by
turning the handwheel towards you.
5
Raise the presser foot and turn the fabric to line the edge with
the 1.6 cm (5/8") seam guide.
Lower the presser foot and begin stitching in the new direction.
2

Variable Needle Position

When the straight stitch (pattern A) is selected, you can move
the needle between center and left needle position by turning
the stitch width dial.
15
* The numbers indicate the distance between the center
needle position and the guide line.
Numbers on the needle plate 10
Distance in centimeters 1.0
1 Guide lines
2
Cornering guide
3
Needle plate
4
Needle plate hole
5 Seam width from the center needle position
Cornering guide
2
15 20 3/8" 4/8" 5/8" 6/8"
1.5 2.0 1.0 1.3 1.6 1.9