Control Panel; Operation - Cuisinart CPK17E Manual De Instrucciones

A. CONTROL PANEL (see fig.1)
1. On/Off Switch
Used to turn the kettle on and off.
2. Button
Used to increase the temperature in increments of 5 degrees from 85°C through to 100°C.
3. 85ºC Button
Temperature setting for coffee and varieties of tea
(refer to quick reference guide on page 12).
4. 100ºC button
Temperature setting for boiling water for a variety of teas
(refer to quick reference guide on page 12).
5. Digital display window (LCD)
Displays temperature setting and the water temperature.
B. OPERATION
• Open the lid by pressing the lid release button located on the top of the handle.
• Fill the kettle with the required amount of cold water. The water gauge is at the rear of the kettle
and is marked with min (0.5L) and max (1.7L) and 2 cup and 4 cup markers.
N.B. Take care not to exceed the max mark as this may cause spitting or leaking from the spout
when boiling.
• Push the lid closed; you will feel and hear a slight «click».
• Align the kettle over the powerbase and gently lower it into position, setting it firmly on the
base.
• Plug the kettle into the mains. The LCD will show the water temperature in increments of 5
degrees.
N.B. On initial use the LCD window will show the ambient water temperature.
• Press the 85°C button or the 100°C button.
• If you want to set the temperature manually, press the «+» button located on the handle. This will
increase the temperature in 5 degree increments from 85°C through to 100°C. The temperature
can only be increased from a starting temperature of 85°C.
• The corresponding temperature button will illuminate and the temperature selected will be
displayed in the LCD window, flashing until kettle is started.
• Press the switch to start boiling; the LCD and water indicator window on the back of the kettle
will illuminate and a beep will sound for 1 second to indicate that heating has started.
N.B. If the switch is pressed but the temperature has not been set, the kettle will default to
100°C.
• When the kettle has reached the selected temperature it will beep 5 times and switch off. The
light illuminating the water indicator window will turn off, whereas the LCD screen will remain lit
for 10 minutes. After these 10 minutes, the light will turn off, but the screen will still display the
water temperature at that point.
• The kettle can be switched off at any time by pressing the
when this happens, the LCD will display the actual water temperature.
N.B. The temperature can be changed at any time during the boiling process by pressing one
of the preset temperature options or setting the temperature manually. If the temperature
button located on the handle;
11