Extremis Bistroo Manual De Instrucciones página 15

locking nuts and 8 M6 wave washers as shown in
the drawing. Caution: Tighten the bolts properly
but not too tight! Max. 4 kg or 8 Nm.
5. Slide the back support onto the legs and attach
the back supports to the legs, each using 2 M6x16
bolts and 1 washer as shown on the drawing.
6. Now tighten the bolts from step 3.
7. Turn the table over so that it is standing on 3 legs.
Attach the 2 backrests to the back support, each
using 3 M6 wave washers and 3 M6 dome nuts.
Table tray - p10
1. Position the table tray in the cut-out of the
tabletop.
Cushion - p10
1. Position the cushion on the seat so that the
silicone plug of the cushion fits into the hole of
the seat.
Floor fastening - p11
1. Turn the table upside down.
2. Remove the leg caps with the help of parrot pliers.
3. Assemble the ground anchoring set as shown in
the drawing.
4. Do not completely tighten the bolt yet.
5. Mark the places on the ground where the
anchoring is to be located and drill at the
indicated points.
6. Use the most appropriate fasteners for the surface
on which the Bistroo is to stand.
7. Tighten all the bolts by tightening the plastic cap
with a key 34.
MAINTENANCE
Powder-coating
CLEANING
Regularly
Use Extremis Multicleaner, a 100% biodegradable
detergent or common kitchen cleaning products.
Avoid using aggressive products. These surfaces are
best cleaned with a neutral cleaning product diluted
in water.
REMOVING STAINS
Only if nothing else helps
The magic eraser gets rid of most stubborn stains
without effort. Only if stubborn stains remain visible
after treatment according to the instructions, you
can use the Extremis Magic Eraser sponge. This
sponge is made of melamine resin and wears away
with use. The sponge is very easy to use and gives
results up to 26 times faster than a traditional
microfibre cloth. The magic sponge is the solution
for getting rid of stubborn stains such as felt-tip
pens, grease, scuff marks, limescale marks or coffee
and tea stains. The magic sponge can be used
on tarpaulin fabric, plastic profiles, glass, steel,
chrome, aluminium, porcelain, artificial leather and
many types of floor.
REPAIRING DAMAGED POWDER-COATING
When damaged
The impact of sharp objects can damage the
coating. Scratches or dents can be touched up with
our paint pens. However this only camouflages the
scratches without removing them.
Wood
DAY TO DAY CLEANING
Clean regularly and after every use
Wood doesn't need much maintenance, but the
better you treat it, the longer it will last. Cleaning
the wood regularly and immediately after use with a
damp cloth will prevent fluids from penetrating deep
into the wood.
Watch the maintenance video on
our website:
www.extremis.com/maintenance
15