Troubleshooting - Honeywell ULTRA GLOW HUL530 Serie Manual De Instrucciones

TROUBLESHOOTING

PROBLEM
No power lights
Power is on and little or
no mist is produced
Lights Blinking
Unit is leaking
Condensation forms around
humidifier or on windows
White dust settling on
surfaces in room
NOTE: Failure to keep this unit clean from mineral deposits normally contained in
any water supply will affect the efficiency of operation of this unit. Failure to follow
these instructions may void the warranty.
POSSIBLE CAUSE
• Unit not plugged in
• Unit is not turned on
• No water in Tank
• Mineral deposits on Nebulizer
• Power setting may be too low
• Auto shut off feature has been
engaged
• The demineralization cartridge
(sold separately) may be beyond
its service life
• Water may have dripped on light
button
• Tank may be damaged
• Tank Cap is not tight
• Tank Cap Gasket may be missing
• Unit may not be on a level
surface
• Mist intensity is set too high
for room size or current humidity
level
• Mineral content in hard water
SOLUTION
• Plug unit in
• Turn unit on
• Fill Water Tank
• Clean Nebulizer (Refer to Cleaning Your
Humidifier section)
• Turn Power knob to the right to
increase mist level
• Reset the humidifier by turning it off for
a few seconds, then turn back on
• Remove Cartridge; contact Consumer
Relations for replacement
• Dry light button with soft cloth
• Check for cracks on tank and contact
Consumer Relations
to replace, if necessary.
• Tighten Tank Cap
• Check to see if Gasket is attached
to inside of Cap; contact Consumer
Relations for replacement
• Be sure unit is level
• Decrease mist output to low setting or
open door to the room
• Dilute tap water with distilled water to
minimize white dust
• PDC51V2 (PDC51CV2 in Canada)
Demineralization Cartridge; contact
Consumer Relations to purchase
9