Publicidad
Step 9
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (H) and lay it over your unit.
Make equal margins along all four edges of the BACK (H).
å
Push on opposite corners of your unit if needed to make it
"square".
Fasten the BACK (H) to your unit using the NAILS (FF).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the SHELF (G) and UPRIGHTS (D and O).
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the holes needed.
Fasten the BASE (K) to the BOTTOM MOLDING (N) with
å
three TIE PLATES (S). Use six BLACK 9/16" LARGE HEAD
SCREWS (DD).
N
S
K
www.sauder.com/services
K
BLACK 9/16" LARGE HEAD SCREW
(6 used for the TIE PLATES)
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
These holes must line up
over the SHELF (G) and
UPRIGHTS (D and O).
H
DD
407432
FF
NAIL
(35 used in this step)
Page 13
Publicidad
