Installation - TiEmme 4HEAT Manual Del Usuario

PinKEY in box
PinKEY recessed

Installation

The following procedures must be carried out to test the device:
1. Connect the 4HEATModule to the power supply:
• 4HEAT: Red(a) solid led and Green(b) flashing led;
• 4HEAT Lite: (a) solid Red led;
• WiKEY: make sure that the heating system is connected to the mains;
• PinKEY: Red solid WI-FI led (a);
2. Connect the 4HEATModule to the TiEmme elettronica board using the cable provided in the kit:
• 4HEAT: solid Red led (a) and solid Green led (b);
• 4HEAT Lite: the Led (a) must be Solid Red, if at the end of the configuration procedure the Led (a) becomes
solid Green the device is not communicating correctly with the controller, make sure that the device is
connected correctly and the heating system is connected to the mains;
• WiKEY: already connected to the heating system;
• PinKEY: the Solid Red WI-FI led (a), if at the end of the configuration procedure the Wi-Fi led (a) becomes
solid Green the device is not communicating correctly with the controller, make sure that the device is
connected correctly and the heating system is connected to the mains;
3. Wi-Fi communication: with the solid Blue Led the communication with the APP is successful and the device is
communicating correctly, while in the WiKEY the Wi-Fi led will be solid;
(a) Wi-Fi Communication
(a) Wi-Fi Communication
(b) Configuration button
(b) Configuration button
5 EN