Descargar Imprimir esta página

TESY CN203ZF Manual De Operación Y Mantenimiento página 3

Convector eléctrico
Ocultar thumbs Ver también para CN203ZF:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17
Do not cover the appliance. If the appliance gets
covered, there is risk of overheating and fire.
If the appliance is damaged or does not work
properly, stop it and do not repair it yourself. For
any kind of repairs call for assistance the after-sale
service centre. This is the place where you will have
your broken part replaced with an original one.
Non-adherence to this instruction will compromise
the appliance safety.
If you decide to stop using such kind of appliance,
it is advisable to render it unusable by cutting its
power cord after disconnecting it from the mains.
It is advisable all possible dangers related to the
appliance to be prevented, especially in relation to
children that may play with out-of-use appliances.
Never keep the appliance unnecessarily switched
on. Disconnect it from the power socket when you
do not intend to use it for a long period of time.
The appliance should not be positioned close under
power sockets!
Warning: Do not use this appliance with a
programming device, counter or any other device
which can automatically switch it on because if the
appliance is covered or improperly positioned this
may cause fire.
Position the power cord in such a way that it does
not obstruct the free movement of people and can
not be stepped on! Use only approved extension
cords which are suitable for this appliance, i.e. have
got a conformity sign!
Never move the appliance by pulling its power cord
and do not use the power cord for carrying objects!
Do not bend the power cord and do not stretch it
over sharp edges, do not position it over hot plates
or open flames!
Never use this appliance in close proximity to wet
premises – bathroom, shower cabin or swimming
pool!
PACKING
After unpacking the appliance, check if all its
elements are included in the packing and that it has
not been damaged during transportation! In case
damage or incomplete delivery is found, contact
your authorized retailer!
Do not throw away the original packing! It could
be used for storage and transportation purposes in
order to avoid damages during transportation!
Disposal of packing materials should be done in
the appropriate way! Children should be prevented
from playing with the polyethylene bags!
English
INSTALLATION AND OPERATIONS INSTRUCTIONS
The appliance is intended only for on-floor
operation (horizontal flat surface)!
Before operating the panel heater you should install
its feet. The feet should be installed at the base of
the panel heater by means of 2 screws to each of
them. Make sure that the feet are properly aligned
at the two sides of the panel heater.
Position of pin
Take out the set of 2x2 screws and attach the feet by
screwing the screws with a proper extra tool (screw-
driver), which is not included in appliance set.
Set the panel heater in proper working position
before connecting it to the mains.
Select a proper place for the appliance, taking into
account the safety precautions.
During initial operation or when the appliance has
not been used for a long period of time, subtle
odour or smoke may be emitted, it will disappear in
a short period of time during appliance operation.
The appliance is equipped with a
double power switch for selection of
power mode - „I" for 800W, ''II" for
1200W. The total maximum power
when both power switches are
turned-on is 2000W(800W+1200W)
The appliance is equipped with
thermo-regulator sensitive to
ambient temperature. You can turn
the thermo-regulator knob until the
desired room temperature is
achieved (the size of the heated
Position of holes
Fixed screw
Usage and Storage Instructions
EN
3

Publicidad

loading