Use Instructions; Visualization Of Inputs Status; Setup And Memorization Of The Motor Stroke - Dea 202RR Instrucciones De Uso Y Advertencias

8 USE INSTRUCTIONS

After making all connections to the terminal board, remember to short-circuit, whenever needed, any
unused input (see "connection to the control board") and power the card: on the display you will read for
a few seconds "rES-" followed by the symbol "----" which stands for gate closed.
8.1 Visualisation of inputs status
Press on the "OK" key to check that all inputs have been properly connected.
Basic installation
By pressing the "OK" key when the control board awaits further instructions ("----") the display shows
some vertical segments: each one of them is associated to one of the control board inputs (see the picture
above). When the segment is lit it means that the contact associated to it is closed, on the contrary, when
it is not lit the contact is open.
8.2 Setup and memorization of motor stroke
WARNING For a correct adjustment of the oil pressure operators, refer to page.25.
WARNING Before the learning of the operators stroke:
• Select the type of operators: with encoder (P034=0 and J8=J10=pos. A); without encoder (P034=1
and J8=J10=pos. B).
• Select the number of operators used: 2 operators (P029=0); 1 operator (P029=1).
• Make sure that eventual safety devices, photocells and limit switches are connected and working cor-
rectly. Their presence is automatically detected by the control panel during the learning.
Instructions
The control board is ready to receive instructions
Scroll down the parameters until you visualize procedure P001
Confirm! The control board is ready for the positioning of leaf 1
Position leaf 1 in its standstill position while opening
Confirm!
Scroll down the parameters until you visualize procedure P002
Confirm! The control board is ready for the positioning of leaf 2
Position leaf 2 in its standstill position while opening
Confirm!
Scroll down the parameters until you visualize procedure P003
Confirm!
Operating instructions and warnings
Complete installation
Function
Leaf 1 positioning
Leaf 2 positioning
Motors stroke memorization
1
1
2 0 2 R R
Display
19