Before Use; Initial Operation; Switching On/Off - Würth SBS 1300-VES Manual De Instrucciones

SBS 1300-VES.book Seite 10 Mittwoch, 14. Februar 2018 10:20 10

Before use

Always use the correct supply voltage: The power
supply voltage must match the information quoted
on the tool identification plate.
Inserting the saw-blade
(see figure )
A B
Always disconnect the plug from the socket
before carrying out any work on the machine.
Open the quick-change 3 holder by turning the
clamping ring in the direction of the arrow and
holding.
Insert the saw blade 1 as far as it will go and
release the tension ring. The saw blade is fixed
automatically. Check that the saw blade is sitting
firmly (wear protective gloves!)
Only use saw blades with adequate length. The
saw blade has to be longer than the working
piece even when working with the lowest stroke
rate (H). Saw blades can break if hit against the
working piece or the guide shoe.
To adjust cutting shoe
(see figure )
C
The saw blade gets worn most in the area just
before the guide shoe. To increase the life of
the saw blade the guide shoe can be moved.
Pull the clamping lever 7 downward and move
the guide bracket to the requested position. Push
the clamping lever up again.

Initial Operation

Switching On/Off

Switching on: Press the On/Off switch 6.
Switching off: Release the On/Off switch 6.
Preselecting the stroke rate
With the thumbwheel 5, the stroke rate (= saw-blade
motion per minute) can be variably adjusted.
Depending on the amount of pressure on the
On/Off switch 6, the stroke rate can be variably
adjusted to the preselected stroke rate on the thumb-
wheel.
Select the suitable stroke rate for the material being
worked from the Table (see page 3) and set the cor-
responding number on the thumbwheel.
10
Orbital action (see figure
Orbital action of the saw blade that can be switched
on allows for optimal adaptation of cutting speed,
cutting capacity and cutting pattern to the material
being worked.
The orbital action can be switched on or off via the
selector switch 4:
Orbital action ON
Orbital action OFF
Recommendations:
– To achieve the smoothest and cleanest cutting
edge, switch the orbital action OFF.
– When sawing thin materials, e. g., steel sheet,
switch the orbital action OFF.
– When sawing hard materials, e. g., steel, switch
the orbital action OFF.
– When sawing soft materials, e. g., wood and
when sawing in the direction of the grain, switch
the orbital action ON.
Operating Instructions
If you want to saw a cut into a panelled wall, check
beforehand if there are any electric or other cables
in the area to be sawn (eg. with metal detector).
When sawing, only hold plastic parts of machine.
This will prevent an electric shock should you saw
through a cable.
In order to avoid vibrations press the guide shoe flat
to the working material when sawing.
Sawing metal
When sawing into metal start with a low stroke rate,
then increase the stroke rate by depressing the switch.
For plunge cutting, first drill a hole which is slightly lar-
ger than the saw blade and then start to cut.
When sawing into metal apply coolant and lubricant
(oil, paraffin oil) along the cutting line.
Plunge cuts (see figure
Plunge cutting is only possible in soft materials.
Switch on machine and rest guide shoe on workpi-
ece, hold housing firmly with one hand at the top
and with your other hand push upwards on the hand
grip, slowly plungeing in the saw blade.
)
D
)
E