Cleaning And Maintenance - Saivod NPO Manual De Instrucciones

OPERATION INSTRUCTION
◆ Ensure the heater is placed on a flat and level surface. Avoid using it on deep pile carpets as
the safety tip over switch may fail to operate and make the heater fail to work. Never use the
heater on chairs, beds or other soft / unstable surfaces.
◆ Check the household voltage to ensure it matches the appliance's rated specification. Be
sure to plug into a 220-240V～ 50/60Hz outlet.
◆ Please note that heater has a safe tip-over switch. If knocked over, the heater will stop
working until it is placed in an upright position.
◆ Heater is equipped with two power settings.
heater,then press "ON/OFF" on the control panel,the heater will work on low power, and
"LO" will light on. When you press the "MODE" button, heater will turn to "HI" position.
◆ Heater contains OSC function and timer settings, when you press "Osc", OSC function will
start to work. Timer settings is MIN at 1h and MAX at 7h, it will add 1h each time in "1h-2h-
3h-4h.....7h-NO-1h-2h...."loop setting.
◆ When heater is on "Sensor" mode, it will work as per your setting mode if it senses a body
within its range (about 30 degree left and right, 2m distance). When it senses all bodies are
out of range, it will close heating function in 2 minutes and change to stand by mode. It will
start working again when it senses anybody walking in.

CLEANING AND MAINTENANCE

Ensure that the device is switched off before cleaning or maintenance.
（1）Before maintaining, please pull out the plug, and make sure the heater has become cool.
（2）Please use soft cloth to wipe the dust on the heater's surface; If the surface is too dirty, it is better
to wipe it with the water lower than 50°C mixed with neutral detergent.
（3）Don't use the gasoline, Thinner and any others which are easy to damage surface.
（4）Please cooling, dry up heater before packing, place it in dry and ventilate place.
Tower heater.indd 21
First press the main switch to "I" behind the
GB
21
6/17/2016 11:19:13 AM