Kohler K-3942-3-NA Guia De Instalacion página 14

Support Rail
10. Install the Support Rails and Sink
To protect the cabinet finish, temporarily apply painter's tape
around the cabinet cutout.
Carefully lower the sink into the cabinet.
From inside the cabinet, mark the bottom edge of the bowl onto
each side wall of the cabinet.
Carefully remove the sink and set aside.
Remove the painter's tape.
Cut two support rails to fit along the inside wall of the cabinet.
Rails should be no more than 1/2" (13 mm) thick.
Position the bottom of the support rail along the marked line.
Verify level.
Secure the rail to the cabinet wall. Ensure that the fasteners do
not extend through the inside walls of the adjacent cabinets.
Apply a bead of 100% silicone sealant around the countertop
cutout.
Carefully lower the sink into the cabinet.
1389373-2-A 14 Kohler Co.