Elko EP RFSA-166M Manual De Instrucciones página 5

Tabla de contenido

Publicidad

RFSA-166M
Wireless switch unit
EN
Unidad inalámbrica de conmutación
ES
Function impulse relay /
Función relé de impulso-telerruptor
Description of impulse relay /
Descripción de función telerruptor
The output contact will be switched to the opposite position by each press of
the button. If the contact was closed, it will be opened and vice versa.
1 x
Programming /
Programación
Press of programming button
1
PRG, AUX on receiver RFSA-
166M for 1 second will acti-
vate receiver RFSA-166M into
programming mode. LED is
fl ashing in 1s interval.
Pulsando el botón de progra-
mación PRG, AUX de la unidad
1 x
> 1s
RFSA-166M durante más de 1
PRG
segundo, entra al modo de la
AUX
programación. LED parpadea
en intervalo de 1 segundo.
Funcion delayed off /
Función retardo a la desconexión
Descripción de función retardo en OFF
Description of delayed off /
The output contact will be closed by pressing the button and opened after the
set time interval has elapsed.
1 x
Programming /
Programación
Press of programming button
1
PRG, AUX on receiver RFSA-
166M for 1 second will acti-
vate receiver RFSA-166M into
programming mode. LED is
fl ashing in 1s interval.
Pulsando el botón de progra-
mación PRG, AUX de la unidad
1 x
> 1s
RFSA-166M durante más de 1
PRG
segundo, entra al modo de la
AUX
programación. LED parpadea
en intervalo de 1 segundo.
After the desired time has
4
elapsed (range of 2s...60min),
the timing mode ends by
pressing the button on the
RF transmitter, to which the
delayed return function is
assigned. This stores the set
time interval into the actuator
memory.
1 x
Después del tiempo deseado
(a menos de 2s...a 60min) el
modo de temporizador se ter-
mina pulsando el botón del
controlador RF, donde está
t = 2s . . . 60min.
asignada la función retardo
en OFF. Tiempo establecido
se guarda en la memoria del
actuador.
ELKO EP ESPAÑA, S.L. | C/ Josep Martinez 15a, bj | 07007 Palma de Mallorca | e-mail: info@elkoep.es | Tel.: +34 971 751 425 | Fax: +34 971 428 076
Made in Czech Republic
2
4 x
2
5 x
5
1 x
ELKO EP, s.r.o. | Palackého 493 | 769 01 Holešov, Všetuly | Czech Republic | e-mail: elko@elkoep.com | Support: +420 778 427 366
www.elkoep.com / www.elkoep.es
Con cada pulsación del botón el contacto de salida cambia la posición. Si estaba
cerrado - se abre, si estaba abierto - se cierra.
Four presses of your selected
button on the RF transmitter as-
signs the function impulse relay
(must be a lapse of 1s between
individual presses).
4x pulsaciones al botón selec-
cionado del RF controlador
asigna la función telerruptor,
entre los pulsos hay que cumplir
retardo de 1s.
Pulsando un botón el contacto de salida se enciende y se apaga después de un
período de tiempo determinado.
Assignment of the delayed
off function is performed by
fi ve presses of the selected
button on the RF transmit-
ter (must be a lapse of 1s be-
tween individual presses).
5x pulsaciones al botón selec-
cionado del RF controlador
asigna la función retardo en
OFF, entre los pulsos hay que
cumplir retardo de 1s.
Press of programming button
PRG, AUX on receiver RFSA-
166M shorter then 1 second
will fi nish programming mode.
The LED lights up according
to the pre-set memory func-
tion.
Pulsando el botón de progra-
mación PRG, AUX de la unidad
< 1s
RFSA-166M durante menos
PRG
de 1 segundo, terminará el
AUX
modo de programación. LED
se ilumina según la función
de memoria ajustada.
02-12/2018 Rev.0
Press of programming but-
ton PRG, AUX on receiver
3
RFSA-166M shorter then 1
second will fi nish program-
ming mode. The LED lights
up according to the pre-set
memory function.
Pulsando el botón de progra-
mación PRG, AUX de la unidad
1 x
< 1s
RFSA-166M durante menos
PRG
de 1 segundo, terminará el
AUX
modo de programación. LED
se ilumina según la función
de memoria ajustada.
Press of programming but-
ton PRG, AUX longer then
3
5 seconds, will activate ac-
tuator into timing mode. LED
fl ashs 2x in each 1s interval.
Upon releasing the button,
the delayed return time starts
counting.
Pulsación al botón de progra-
1 x
> 5s
mación PRG, AUX a más de
PRG
5 segundos, activará modo
AUX
temporizador. LED parpadea
2x en intervalos de 1 segun-
do. Después de soltar el botón
comienza el tiempo de retar-
do en OFF.
5 / 8

Publicidad

Tabla de contenido
loading

Tabla de contenido