Sears Kenmore 106.7200 Manual De Uso Y Cuidado página 11

IMPORTANT:
a_
d_us_ _he Doos
Your refrigerator has two adjustable, front leveling screws - one
on each side of the refrigerator base. If your refrigerator seems
unsteady or you want the door to close easier, use the
instructions below.
Before moving the refrigerator, raise the leveling screws so the
front rollers are touching the floor.
Remove the base grille. Grasp the grille firmly and pull it
toward you.
2.
Raise or lower the cabinet.
Using a 1/4" hex driver, turn the leveling screw on each side to
raise or lower that side of the refrigerator.
NOTE: Having someone push against the top of the refrigerator
takes some weight off the leveling screws. This makes it easier
to turn the screws. It may take several turns of the leveling
screw to adjust the tilt of the refrigerator.
• To raise, turn the leveling screw clockwise.
• To lower, turn the leveling screw counterclockwise.
1. Turn off the ice maker by opening the freezer door and lifting
up the wire shutoff arm as shown.
2.
Install the interior water filter. The interior water filter mounting
bracket is located on the left side wall of the refrigerator
compartment.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Remove blue bypass cap and retain for later use.
Gently remove the interior water filter from its packaging.
Remove the sealing label from the end of the filter and
insert it into the filter head.
Gently rotate the filter clockwise until it stops. Then snap
the filter cover closed.
0
A. leveling screw
3. Open the door again to make sure that it closes as easily as
you like. If not, tilt the refrigerator slightly more to the rear by
turning both leveling screws clockwise. It may take several
more turns, and you should turn both screws the same amount.
4. Replace the base grille.
Please read before using the water system.
IMPORTANT: After connecting the refrigerator to a water source or
replacing the water filter, follow the steps below to make sure that
the water system is properly cleaned. This will flush air from the
filter and water dispensing system, and prepare the water filter for
use.
3.
4.
5.
Press the Water button on the dispenser control panel. Use a
sturdy container to depress and hold the dispenser lever for
5 seconds, then release it for 5 seconds. Repeat until water
begins to flow. Once water begins to flow, continue depressing
and releasing the dispenser lever (5 seconds on, 5 seconds off)
until a total of 4 gal. (15 L) has been dispensed. This will flush
air from the filter and water dispensing system, and prepare
the water filter for use. Additional flushing may be required in
some households. As air is cleared from the system, water may
spurt out of the dispenser.
NOTE: After 5 minutes of continuous dispensing, the dispenser
will stop dispensing water to avoid flooding. To continue
dispensing, remove the container and press the dispensing lever
again.
Inspect the filter system for water leaks. If you see water leaks,
see the "Troubleshooting" section.
Turn on the ice maker by opening the freezer door and
lowering the wire shutoff arm as shown. Please refer to the "Ice
Maker" section for further instructions on the operation of your
ice maker.
• Allow 24 hours to produce the first batch of ice.
• Discard the first three batches of ice produced.
11