Door Ajar Alarm - Sears Kenmore 106.7200 Manual De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Door Ajar Alarm
The Door Ajar feature
sounds a chime every few seconds when the
refrigerator
door
has been left open for 5 continuous
minutes.
The
chime will sound until the door is closed or Door Ajar
is turned
off.
The light bulbs will turn off if any door is left open for 6 continuous
minutes.
Closing
all the doors for 1 second
will cause the lights to
come back on.
Press the Door Ajar touch pad to turn this feature
on or off. The
indicator
light will be lit when the Door Ajar
feature
is on.
Humidity
Control
(on some models)
The Humidity
Control
feature
turns on a heater to help reduce
moisture
on the door hinge seal. Use in humid environments
or when
you notice moisture
on the door
hinge seal. The refrigerator
uses
more energy
when Humidity
Control
is on.
Press Humidity
Control
when the environment
is warm
and more
humid, or if you notice moisture
on the door hinge seal. The
indicator
light will be lit when humidity
control
is ON.
Press Humidity
Control
again
to turn OFF and save energy
when the environment
is less humid.
Press If Moisture
Appears
Temp
Alarm
(on some models)
The Temp Alarm
feature
provides
temperature
information
in the
event of a power
outage.
Power outage:
During
a power
outage,
if the temperatures
in the
refrigerator
and freezer
compartments
exceed
normal
operating
temperatures,
the highest temperature
reached
will be displayed.
Press the Temp Alarm
touch pad until the indicator
light is lit, to
turn on this feature.
Press and hold Temp Alarm
for 3 seconds
until the indicator
light goes off, to turn off this feature.
Temperature
alarm:
An alarm
will sound repeatedly
if the freezer
or refrigerator
compartment
temperatures
exceed
normal
operating
temperatures
for an hour or more.
The temperature
displays
will alternately
show the current
temperatures
and the highest
temperatures
the compartments
reached.
Press the Temp Alarm
touch pad once to stop the audible
alarm
and alternating
temperature
displays.
The Temp Alarm
light will continue
to flash until the refrigerator
returns to the set
temperature.
Filter Reset (on some models)
The Filter Reset control
allows
you to restart the water
filter status
tracking
feature
each time you replace
your water
filter. See
"Water
Filtration
System."
Press and hold the Filter Reset touch pad for 3 seconds, until the
Replace
light turns off.
Order
Replace
Press & Hold
User Preferences
The control
center
allows
you to set user preferences,
if desired.
Temperature
Display
(F_C)
This preference
allows
you to change
the temperature
display.
F - Temperature
in degrees
Fahrenheit
C - Temperature
in degrees
Celsius
Alarm
(AL)
This preference
allows
you to turn off the sound of all alarms.
ON - You will hear the alarm
sound.
OFF - You will not hear the alarm
sound.
Sabbath
Mode
(SAB)
ON - All control
center
lights and alarm
tones will be disabled.
OFF - All control
center
lights and alarm
tones will be enabled.
NOTE:
Press the Door Ajar touch pad for 3 seconds to restore all
lights.
To Accessthe User PreferencesMenu:
1.
Press and hold the Door Ajar touch
pad for 3 seconds.
The
preference
name will appear
in the Freezer display
and the
preference
status (F or C) or (ON or OFF) will appear
in the
Refrigerator
display.
2.
Use the Freezer Up Arrow
or Down Arrow
touch pads to scroll
through
the preference
names. When
the desired
preference
name is displayed,
press the Refrigerator
Up Arrow
or Down
Arrow
touch pads to change
the preference
status.
3.
Set your preferences
by pressing
and holding
the Door Ajar
touch pad for 3 seconds.
IMPORTANT:
After connecting
the refrigerator
to a water
source or replacing
the water
filter, flush the water
system. Use a sturdy container
to depress and hold the dispenser
lever for 5 seconds, then
release it for 5 seconds. Repeat
until water
begins to flow.
Once water
begins
to flow, continue
depressing
and releasing
the dispenser
lever (5 seconds on, 5 seconds off) until a total of
4 gal. (15 L) has been dispensed.
This will flush air from the filter
and water
dispensing
system, and prepare
the water
filter
for
use. Additional
flushing
may be required
in some households.
As air is cleared
from the system, water
may spurt out of the
dispenser.
Allow
24 hours for the refrigerator
to cool down and chill
water.
Dispense enough
water
every week to maintain
a fresh
supply.
14

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Kenmore 106.7201

Tabla de contenido