Kohler K-T9493 Guia De Instalacion página 7

Volume Control
Valve
Adhesive
Gasket
Collar
K-T9493
Escutcheon
Collar
Finished
Wall
Collar
Mixing
Valve
Adhesive
Gasket
K-T9494
Screw
Escutcheon
Drain
Opening
2. Install the Trim
Installing Mixing Valve Trim (K-400 and K-401 Models)
Remove and discard the plaster guard if it is still in place.
Thread the collar(s) to the valve and hand tighten.
Verify that each trim seal is correctly installed in an escutcheon
hole. The seal(s) should be installed so the flat side faces outward
and the tapered side faces inward.
Remove the backing from the adhesive gasket material. Starting
at the escutcheon drain opening, carefully apply the gasket
material around the back edge surface of the escutcheon.
Once applied, carefully trim away any excess gasket material so
the escutcheon drain opening is not blocked.
Carefully slip the escutcheon over the collar(s) and against the
finished wall. Position the escutcheon so the "Kohler" logo is at
the top.
Secure the escutcheon to the valve with two screws.
Kohler Co.
Rotate
counterclockwise.
Screw
Screw
Trim
Seal
Round Handle
Volume
Control Knob
"Off"
"High"
7
Lever Handle
Volume Control
Knob
O-Ring
Cap
Detent
Screw
Cap
Grip
Detent
Ring
O-Ring
1012606-2-B