Kit Preparation - Metra 95-6554B Instrucciones De Instalación

Attention! The sub-dash of the vehicle
will have to be cut to allow room for the
aftermarket radio. Once cut, the factory radio
will no longer be able to be re-installed. Also
take note that the radio sub-dash is actually
the a/c vents for the vehicle. After the
sub-dash has been cut, the tape provided
will have to be used to cover up the holes to
prohibit air from leaking out.
For select Sony radios* with an "L" shaped
chassis design:
1. Remove (4) Phillips screws securing
the climate controls. Partially slide the
controls out and move down slightly.
2. Cut the sub-dash to allow room for the
aftermarket radio. (Figure B)

KIT PREPARATION

(Figure A)
Remove shaded area
(Figure B)
3. Apply tape over the area cut. (Figure C)
4. Cut the radio brackets as shown.
(Figure D)
5. Secure the climate controls back to the
vehicle using just the (2) lower screws.
The upper screws will be reused in
Kit Assembly.
* At present (9-12-19), models XAV-AX100,
XAV-AX1000, XAV-AX200, XAV-A500, and
XAV-V10BT have this design
Continue to Kit Assembly
Tape over the cut area
(Figure C)
Remove shaded area
(Figure D)
REV. 8/6/2021 INST95-6554B
3