Kit Preparation - Metra 99-5835G Instrucciones De Instalación

From the factory radio trim panel:
1. Remove (1) screw per vent, then
unclip and remove the vent. (Figure A)
2. Unclip and remove the hazard
switch. (Figure B)
3. For models without a 4.2-inch
display screen only: If the vehicle
is equipped with a passenger airbag
light, unclip and remove the light.
(Figure A)
(Figure B)

Kit Preparation

To the 99-5835G radio trim panel:
1. Secure the vents to the panel using
the (2) #8 x 3/8" Phillips pan-head
screws provided. (Figure C)
2. Snap the hazard button into the
panel (Figure C).
3. Attach the (4) plastic panel clips
provided, to the panel. (Figure D)
For models without a 4.2-inch
display screen:
a.
If equipped without a passenger airbag
light, snap the passenger airbag light
blank into the panel. (Figure C)
b. If equipped with a passenger airbag
light, snap the factory passenger
airbag light into the panel .
For models with a 4.2-inch
display screen:
a. I
f equipped without a passenger airbag
light, snap the passenger airbag light
blank into the panel. (Figure C)
b. If equipped with a passenger airbag
light, snap the passenger airbag
light provided, into the panel.
99-5835G
To the 99-5835G dash panel:
1. Attach the (12) metal panel clips
provided, to the panel. (Figure E)
Continue to kit assembly
(Figure C)
(Figure D)
3
(Figure E)