Kit Preparation; Kit Assembly - Metra 95-7376B Instrucciones De Instalación

KIT PREPARATION

1. Remove the (3) Phillips screws securing
the A/C vents to the factory radio trim
panel and then remove. (Figure A)
2. Secure the vents onto the radio trim
panel using the factory hardware.
(Figure B)
Continue to Kit Assembly
(Figure A)
(Figure B)

KIT ASSEMBLY

1. Attach the radio brackets to the radio
using the screws supplied with the radio.
(Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS. Test the radio for proper
operation.
3. Secure the assembly into the dash
opening using the factory hardware.
4. Snap the radio trim panel over the radio
assembly, and then reassemble the dash
in reverse order of disassembly.
(Figure A)
REV. 1/6/2022 INST95-7376B
3