1. Cut and remove the shaded area from
the sub-dash to allow clearance for the
aftermarket radio. (Figure A)
If retaining SYNC:
2. Attach the SYNC module brackets to the
factory SYNC module using the (4) #8 x
3/4" Phillips pan-head screws provided
with this kit. (Figure B)
3. Plug in all factory connectors, previously
removed, into the SYNC module, and
then secure the module into the lower
sub-dash using the factory screws.
(Figure C)
Continued on the next page
KIT PREPARATION
Remove
shaded area
(Figure A)
Note orientation
of arrow
(Figure B)
(Figure C)
REV. 6/30/22 INST99-5838CH
5