Kit Preparation; Kit Assembly - Metra 95-6506B Instrucciones De Instalación

KIT PREPARATION

1. Cut and remove the sub-dash to allow
clearance for the aftermarket radio.
(Figure A)
Continue to Kit Assembly
Remove shaded area
(Figure A)

KIT ASSEMBLY

ISO DDIN radio provision
1. Attach the radio brackets to the radio
using the screws supplied with the radio.
(Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra.
Test the radio for proper operation.
3. Secure the completed assembly into the
dash using the factory screws.
4. Reassemble the dash in reverse order
of disassembly.
(Figure A)
REV. 5/14/2018 INST95-6506B
3