Kit Preparation; Kit Assembly - Metra 99-7353CH Instrucciones De Instalación

Kit Preparation

1. Mount the a/c vents, storage pocket,
hazard switch, and passenger air
bag indicator into the Radio Housing
Trim Panel using screws removed in
disassembly. (Figure A)
Note: For models without an airbag light,
a blank plate and (3) #8 x 3/8" Phillips
Truss-Head Screws are provided.
2. Mount the start/stop switch or blank
plate depending on your application
into the Radio Housing Trim Panel.
Note: An airbag-light
blank plate and screws
are included for
non-US models.
(Figure A)
Note: If no switch is present there
are (2) #8 X 3/8" Phillips truss
head screws supplied to mount the
blank plate.
3. Install the (8) panel clips removed
in disassembly onto the Radio
Housing Trim Panel.
Continue to kit assembly
99-7353CH
ISO DIN radio provision with pocket
1. Mount the pocket to the radio
brackets with the (2) #8 X 3/8"
Phillips pan head screws supplied.
(Figure A)
2. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
3. Slide the radio between the radio
brackets and secure with screws
supplied with the radio. (Figure B)
4. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the radio for proper operation.
5. Reassemble the dash in reverse
order of disassembly.
3

Kit Assembly

(Figure A)
(Figure B)