Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Product Safety Information
Intended Use:
This Sander is designed for light sanding, feather edging and rust removal.
For additional information refer to Rotary Air Sander, Polisher and Buffers Product Safety Information
Manual Form 04580387.
Manuals can be downloaded from www.irtools.com.
Product Specifications
Free
Speed
Model
rpm
317A
18000
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain condensate from
valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a properly sized Safety Air Fuse
upstream of hose and use an anti-whip device across any hose coupling without internal shut-off, to prevent
hose whipping if a hose fails or coupling disconnects. See drawing 16578577 and table on page 2.
Maintenance frequency is shown in circular arrow and defined as h=hours, d=days, and m=months. Items
identified as:
1.
Air filter
2.
Regulator
3.
Lubricator
4.
Emergency shut-off valve
5.
Hose diameter
Sandpaper Installation
•
Disconnect the air supply before servicing or changing the sanding pads.
•
Backing Pads (16) should be inspected for signs of irregularities such as fractures, excessive wear,
nicks, cuts, at the edges of center hole. Pads showing such characteristics should not be used.
Aluminum oxide, resin bond abrasive paper is recommended. Paper can have 7/8" diameter center hole, or
pressure sensitive adhesive.
Select Proper sandpaper and pad for application. Use either resin-backed or pressure-sensitive sandpaper.
For resin-backed paper:
1.
Insert Pad Nut (15) through sandpaper and Backing Pads (16).
2.
Always use both Backing Pads (discs), with 3" pad positioned closest to sander. Make sure the pad's
label faces the Sander. See illustration (Dwg. TP PF150).
3.
Thread Pad Nut (15) into Flange (14) of Sander.
4.
Hold sanding adapter with the Insert Holding Tool (17). Turn backing pad and sandpaper until Pad Nut
(15) is tight against Flange (14).
5.
Remove Insert Holding Tool (17).
Form 04580395-Edition 2
Pad Diameter
inch
mm
5
127
6.
7.
8.
9.
WARNING
Sound Level dB (A)
(ISO 15744)
Pressure (L
)
p
"K
"=3dB(A)
"K
pA
86.7
Thread size
Coupling
Safety Air Fuse
Oil
Vibration Level
(ISO 8662)
Power (L
)
w
"=3dB(A)
wA
99.7
m/s²
1.2
3
Publicidad
Tabla de contenido
