Beper P204CAL001 Manual De Instrucciones página 10

Ironing System Use instructions
Do not use the appliance in the presence of explosives, highly flam-
mable substances, gases or open flames.
Do not leave the cord hanging from the edge of the worktop or near
hot surfaces.
Do not leave the appliance exposed to atmospheric agents such as
rain, wind, snow, hail etc. Do not use outdoors.
This appliance must only be used for domestic use for which it was
expressly designed. Any other use is to be considered improper and
therefore dangerous. The manufacturer cannot be responsible for
any damage resulting from improper, erroneous or unreasonable use.
Do not place objects on the appliance due to fire hazard.
Do not insert metal objects into the slots of the appliance.
Do not leave the iron unattended when connected to the net-
work.
Caution! Do not open the tank cap when the appliance is in
pressure!
Warning: this symbol
duct is in operation.
Product description Fig.A
1. Iron base
2. Iron connection cable (supply cable + steam hose)
3. Power cable
4. Boiler on/off switch
5. "Steam ready" light
6. Iron on/off switch
7. Boiler safety cap
8. Tank
9. Thermostat knob
10. Steam and continuous steam button
11. Thermostat light
Mode use
Attention: iron only on surfaces resistant to heat and on surfaces that allow the passage of steam,
such as ironing boards specific for this type of ironing.
Note: the iron is designed to use tap water, however, if the water is very hard, it is advisable to use a
mixture of distilled water and tap water.
Unscrew the safety cap and fill the tank with about 0.75 litres of water with the help of the funnel and make sure
it does not overflow.
Screw the cap back and make sure it is firmly closed, otherwise it is possible to run risky steam leaks around
the cap.
Plug the power cord into a power outlet.
indicates: hot surface when the pro-
10