GE 26958 Manual De Instrucciones página 9

9. Set the RINGER switch on the cordless
handset to ON.
10. Plug the power supply cord from the
cordless handset charger into an AC electrical
outlet.
11. Place the handset in the recharge cradle and
charge for 12 hours. The CHARGE indicator
(on the recharge cradle) comes on to indicate
that the battery is charging. If you don't
charge the handset battery properly (for
12 hours) when you first set up the
phone, performance of the battery will
be compromised.
VERY IMPORTANT: You must complete the corded base unit connections
before the cordless handset can be used. Otherwise, it WILL NOT work. See
steps 1-8 of this section.
INSTALLATION NOTE: Some cordless telephones operate at frequencies that
may cause interference to nearby TVs and VCRs. To minimize or prevent such
interference, the base of the cordless telephone should not be placed near or on
top of a TV or VCR. If interference continues, moving the cordless telephone
farther away from the TV or VCR will often reduce or eliminate the interference.
9
FORMAT
DIAL TALK
PAUSE
REDIAL
E
1 2
ABC
4 5
GHI JKL
7 8
TUV
PQRS
* 0
TONE OPER
ANSW
CHANNEL INT
10
CHARGE
PROG
MUTE
11
DELETE
MEM
3
DEF
6
MNO
9
WXYZ
#
FLASH
9