Scope of delivery
The scope of delivery for the appliance is shown on the
packaging. Check the contents for completeness when
unpacking. If any accessories are missing or in the
event of any shipping damage, please notify your deal-
er.
Symbols on the device
Follow all warning notices and safety instruc-
tions. Read and comprehend all instructions
before using the product.
Always wear suitable eye protection and
hearing protection when working with the de-
vice.
Do not subject the device to rain or moist
conditions.
Do not use saw blades or metal blades.
Danger due to flung objects. Keep a safe dis-
tance away.
Hand injuries from sharp cutting tool.
Description of the device
The maximum amount of equipment is described in
these operating instructions. Depending on the model
used, there are differences in the scope of delivery (see
packaging).
For the illustrations, refer to the graphics page
Illustration A
Rear handle
1
Unlocking button
2
Battery pack release
3
Power switch
4
Front handle
5
Handle screw
6
Upper shaft
7
Telescoping collar
8
Twist collar
9
Lower shaft
10
Pivoting head
11
Plant guard bracket
12
String guard
13
Cutting edge
14
Cutting string
15
20
Reel cover
16
Reel cover release
17
Cutting tool
18
a) String reel
b) Trimmer blade
Eye
19
Button for releasing the string
20
*Rechargeable battery pack
21
*Charger
22
Type plate
23
* optional
Rechargeable battery pack
The device can be operated with a Kärcher 18 V Bat-
tery Power battery pack.
Installing the string guard
WARNING
Blade on the string guard
Incision injuries
Install the string guard before using the device for the
first time.
WARNING
Exposed string
Incision injuries
Never use the device without the string guard.
Illustration B
The string guard must face the operator.
1. Insert the string guard into the bracket.
2. Screw the string guard to the bracket.
When assembling the components, make sure that the
side recesses match.
1. Assemble the sprocket.
2. Mount the string guard cover.
3. Insert a tool (e.g. screwdriver) through the recesses
on the side to prevent the support from rotating.
4. Mount the string reel.
Installing the front handle
1. Screw the front handle to the upper shaft section at
the desired height.
Illustration C
1. Release the telescoping collar counterclockwise.
Illustration D
2. Pull out the upper shaft until the desired length is
reached.
3. Tighten the telescoping collar clockwise.
Adjusting the string length
1. Press the button for releasing the string and pull the
string out of the string reel and up to the cutting
edge. If necessary, press the button several times.
Illustration E
English
Autogoods "130"
Installation
Mounting the string reel
Initial startup
Adjusting shaft length