Connect The Cables - Axis Communications Q1910 Guia De Instalacion

AXIS Q1910/Q1910-E Installation Guide
Install the camera on the bracket
1. Install the camera with the bottom cover on the bracket and tighten the bracket screws.
2. Remove the gasket from one of the holes in the bottom cover, see illustration on page 7.
3. Route the cable through the hole and attach the cable gasket to the hole.
4. Connect the cables, see
5. Take the top cover and attach the safety wire to the tab on the bottom cover.
6. Connect the window heater to the window heater connector on the thermal camera.
7. Install the top cover and tighten the bottom cover screws.
8. Install the cable cover and tighten the cable cover screws.
9. Loosen the sun screen adjustment screws and adjust the sun shield to the front position.
10. Loosen the bracket adjustment screw to aim the camera to the point of interest. See
video stream,
on page 14 for information on how to view the video stream.

Connect the cables

1. Optionally insert an SD memory card (not included) into the SDHC (Secure Digital High
Capacity) card slot. A standard or high capacity SD card is required to store images locally in
the camera.
2. Optionally connect external input/output devices. See page 17 for information on the terminal
connector pins.
3. Optionally connect an active speaker and/or external microphone.
4. Connect the camera to the network using a shielded network cable.
5. Connect power, using one of the methods listed below:
• PoE (Power over Ethernet, Class 3). If available, this is automatically detected when the
network cable is connected.
• Connect an external power adapter to the power connector block, see
page 17 for wiring information.
6. Check that the indicator LEDs indicate the correct conditions. See the table on page 19 for
further details.
Connect the cables,
on page 9.
Page 9
Access the
Unit connectors,
on