General Description - GYS STARTPACK TRUCK Manual De Instrucciones

This manual contains safety and operating instructions. Read it carefully before using the booster for the first time and
keep it in a safe place for future reference.

GENERAL DESCRIPTION

This booster is designed for starting 12V and 24V vehicles. It contains two 12V internal batteries with a 22Ah capacity.
CHARGE THE INTERNAL BATTERY
WARNING!
Before using the device turn the knob to OFF.
Charge the device once bought and after each use with the charger provided.
Do not use another charger than the one provided with the device.
This device is delivered with an automatic charger (for the internal battery), double insulated with a floating system
enabling to keep the internal battery charged to 100% unsupervised.
To charge the internal battery :
• Place the device vertically during charging to avoid acid leaking and damaging the internal battery.
• Turn the knob to 12V to start charging.
• Connect the STARTPACK TRUCK with the cigarette lighter connection. The cigarette lighter green LED lights when the
charger is plugged. If it does not, check the internal fuse of the cigarette lighter plug and make sure that the main switch
is on 12V.
• Plug the external charger to a single phase power supply.
• The charge is indicated with a red LED on the external charger.
• The device is charged once this LED turns back to green.
• After a start, leave the STARTPACK TRUCK plug a few minutes to pre-charge it. A charge on the mains is necessary and
extend the lenght of life of the product.
CONNECTION AND DISCONNECTION
IMPORTANT! Before connecting to a battery, check that the device is not connected to the power supply and the switch
is OFF (if any).
Secondly, check the polarity of your battery.
Starting a vehicle:
When the battery negative terminal is connected to the vehicle chassis:
• Connect the red clamp to the positive terminal of the battery.
• Connect the black clamp to the vehicle chassis, ensure it is not close to fuel lines and the battery.
• After use, turn the switch to OFF (if any), disconnect the charger from the mains then disconnect the black clamp and
finally the red clamp.
Some vehicles have the battery positive terminal connected to the chassis, in this case:
• Connect the black clamp to the negative terminal of the battery.
• Connect the red clamp to the vehicle chassis, ensure it is not close to fuel lines and battery.
• After use, turn the switch to OFF (if any), then disconnect the charger from the mains then disconnect the red clamp
and finally the black clamp.
USE IN STARTING MODE
• Do not disconnect the battery from the vehicle. Disconnecting the battery may result in loss of information and a
possible inability to restart.
Starting
• Once the Booster is connected to the battery as recommended (see connection and disconnection), put the switch to
12V or 24V position according to the vehicle to start.
• Go to the vehicle driver side. Turn the key to activate the starter function.
If the engine doesn't start wait 3 minutes between each start attempt. If you do not wait or the start attempt is too long
you will reduce your chance to start the vehicle. Each start attempt must not exceed 5 seconds.
NB: A vehicle that will not start can be caused by a problem other than a battery in poor condition.
• After use follow the recommended disconnection procedure.
The device must be charged after each use in order to keep its batteries in good condition.
STARTPACK TRUCK
EN
5