Tabla de contenido
Publicidad
GAS PATH BASIC SETTING (CALIBRATION)
The controller must be recalibrated with the transmitter whenever
the following points come into effect:
•
When you put the controller into operation for the first time;
•
If you want to use a new station;
•
If you change the neutral position settings, throttle, ATV or
EPA parameters, etc.
a) Turn the controller off and the transmitter on. Set the value of
"EPA / ATV" of the gas channel to "100%" and deactivate the
"ABS" brake function of your transmitter.
b) Hold the "SET" button down and then switch on the controller.
When the red LED starts flashing, release the button immedia-
tely.
c) Calibrate the three points as shown in the steps in the follow-
ing figure.
Neutral position
1
2
Full scale deflection forward
3
Full scale deflection reverse/brake
d) When the calibration process is complete, turn off the control-
ler. The controller can then be switched on and used again.
Move the throttle lever to the neu-
tral position.
1
Press the Set key. The green LED
flashes 1x / the motor beeps 1x.
LED status in driving mode
a) When the throttle is in the neutral position, neither the red nor
the green LED is lit.
b) The red LED lights up when the model is moving forward or
backward and when the model is braking.
GB // 12
During calibration, the three positions of the throttle lever must
be stored. These are the end point for "Forward", "Reverse" and the
neutral middle position of the throttle lever.
The following pictures/steps show how to set the calibration of the
controller:
Move the throttle lever to full
throttle position.
2
Press the Set key. The green LED
flashes 2x / the motor beeps 2x.
c) The green and red LED lights up when the throttle is moved to
full throttle position.
Move the throttle lever to full brake
position.
3
Press the Set key. The green LED
flashes 3x / the motor beeps 3x.
Publicidad
Tabla de contenido
