Protection Function; Programming The Controller - Carson Dragster Brushless-Set Manual De Instrucciones

Warning beeps
a) Alarm sound for incorrect input voltage:
After the controller is switched on, it starts to check the input
voltage. If the voltage is outside the normal range, the controller
emits an acoustic signal:

Protection function

a) Undervoltage protection shutdown:
If the voltage of the Li-Po battery is lower than the preset value for
more than 2 seconds, it switches off the output power. Please note
that the speed controller cannot be restarted if the voltage of the
individual lithium cell is lower than 3.3V (standard value).

PROGRAMMING THE CONTROLLER

a) Programming via the "Setup" button on the controller:
"Beep-beep, beep-beep, beep-beep" (1 second pause between
each "beep-beep" sound).
b) Overheating protection:
When the temperature of the controller reaches a factory-set value
for 5 seconds, the controller interrupts the output power.
c) Protection in case of loss of transmitter signal:
The speed controller stops the output power as soon as the loss of
the transmitter signal is interrupted for more than 0.2 seconds.
13 // GB