Uline H-2307 Instrucciones De Montaje página 2

3. Mark the four holes on the wall where screws will be
inserted. (See Figure 3)
Figure 3
Recommended Mounting Locations
NOTE: This dispenser is designed to
accommodate thin towels and heavy duty
wipers.
1. Before loading product, review which setting the
dispenser opening displays. "0" should be for thick
wipers. "6" should be for thin paper. (See Figure 5)
NOTE: If towels are too easy to pull, decrease
the dial setting.
Thick Wipers
PAGE 2 OF 9
MOUNTING INSTRUCTIONS CONTINUED
DISPENSER SETTINGS
Figure 5
Thin Paper
4. Drill into wall at four marked locations with an
appropriate drill bit. (See Figure 4) Insert wall
anchors if necessary.
Figure 4
5. Hold dispenser over previously drilled holes and
insert screws.
2. To adjust the dial, use dispenser key. Place the key
into the four-pronged circle with pointed end facing
in. The key should fit between two of the prongs.
(See Figure 6)
3. Twist the key firmly to desired setting. Twisting the key
clockwise will increase the number, while
counterclockwise will decrease.
Figure 6
0521 IH-2307