Dometic FreshWell 2000 Instrucciones De Montaje página 23

Dometic FreshWell 2000
Note on electrical system (see fig. b)
No. in fig. b Description
1 Motor ventilator (inner)
2 Motor ventilator (outer)
3 Capacitor
4 Compressor
5 Temperature sensor
6 PCB
7 PCB Display
 Only a qualified electrician should connect the under-bench air condition-
er to the electrical power.
 Check that the voltage specification on the type plate is the same as that
of the power supply.
 Do not lay cables which are loose or bent next to electrically conductive
material (metal).
 Install an all-pole switch with a contact opening width of at least 3 mm on
the installation side.
There are two ways of installing the under-bench air conditioner:
 Installation with the two angle sections (chapter "Fastening with the angle
section" on page 22).
 Installation with the four fastening brackets and the belts (chapter "Install-
ing in a roof hatch opening already provided" on page 22).
EN
Installation
21