Installing The Receiver - Dometic FreshWell 2000 Instrucciones De Montaje

Installation
7.2 Making openings
See fig. 3
➤ Mark the position and size of the openings using the template included in
the packaging (A and B).
See fig. 4
➤ Drill out the corners (A).
➤ Carefully cut out the opening on the roof using a keyhole saw or a similar
tool (B).
Make sure no electrical power cables are damaged.
➤ Drill out a condensation water drainage opening with a diameter of 32 mm
(C).
See fig. 5
➤ Mark the position of the angle sections (A) or the fastening brackets (B)
according to the way you've chosen to fix the under-bench air conditioner.
7.3 Fastening with the angle section
See fig. 6
➤ Fasten the under-bench air conditioner with the two angle sections an
three fastening screw for each as shown.
7.4 Installing in a roof hatch opening already provided
See fig. 7
➤ Fasten the four fastening brackets (A).
➤ Pull the belts through the fastening brackets (B).
➤ Fasten the under-bench air conditioner with the belts (C).
7.5

Installing the receiver

See fig. 8
➤ Drill an opening of 50 mm into the wall.
See fig. 9
➤ Lay the cable through the hole to the under-bench air conditioner.
➤ Fasten the receiver as shown.
22
Dometic FreshWell 2000
EN