Performing Resuscitation; Switch On Device - Weinmann MEDUCORE Easy Descripción Del Aparato E Instrucciones

6.2 Performing resuscitation

Switch on device

Open the lid of the MEDUCORE Easy. This switches on the
device and performs a short self-test. All the status indica-
tors and display fields light up briefly in this process.
Once the self-test is complete, the status indicators indi-
cate the status of the device. The device is ready for use
when the green status indicator comes on permanently.
Warning!
Do not use the device if the red status indicator is
permanently on and the message "Device is not
ready for use" is heard. The device is not ready for
use. Have the device repaired by the manufacturer
Weinmann or an authorized dealer.
Caution!
If one or more of the status indicators and display
fields does not come on during the self-test when
the device is switched on, this indicates defective
LEDs. Use the device for the current use. Have the
device repaired by the manufacturer Weinmann
or an authorized dealer immediately after use.
Caution!
If the green and yellow status indicators come on
permanently after the device is switched on, the
capacity of the battery pack/rechargeable battery
pack is adequate for another 10/6 shocks. Use the
device for the current use. Only change the bat-
tery pack/rechargeable battery pack after use.
EN
Operation 23