Using "Quick Connectors - brondell Capella Manual Del Proprietário

PRODUCT INSTALLATION
Step 6:
Water Storage Tank Prep/Using "Quick Connectors"
WARNING: DO NOT tamper with the air valve cap on the front of the water
storage tank. It has been preset at 6psi.
1. Apply Teflon tape around the
threaded outlet on top of the
water storage tank.
2. Screw the Tank Ball Valve tightly
to the top of the tank.
3. Place the tank on the tank stand
with the valve upright, and
position it underneath the sink
next to the system assembly.
WARNING: DO NOT hold the ball valve to lift or carry the tank. Personal injury or
property damage may result if the valve breaks off.

Using "Quick Connectors"

Tube connections on the T-valve, Filter Head Connection
Assembly, and Indicator Faucet are all of the "Quick
Connect" variety. The steps below illustrate how to
connect and disconnect the tubes from these connectors.
a. Push the tube into the Collet. The collet is a collar
that provides a secure fit for the Tube and prevents
water leaks.
b. Push the tube in until it stops. The tube will
be secure and resistant to tugs or pulls. The
collet will be rigid and raised slightly from the
Connector Housing.
c. To disconnect the tube, push down and hold the
collet first, and then pull the tube out gently.
NOTE: Visit brondell.com for our Quick Connect
Tutorial Video.
Step 1
Air
Pressure
Valve
Stand
Step 2
Collet
Tube
Step 3
Connector
Housing
Step a
Step b
Step c
15