brondell Capella Manual Del Proprietário página 32

H20+ filtración de agua por ósmosis inversa
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TECHNICAL INFORMATION
Troubleshooting
Problem
Unexpected flow
in drain line
No drain flow
Bad tasting water
Cloudy water
Leaking water from
the Capella
30
Possible Cause(s)
The auto shut-off valve
is inoperative
1. Other filters or E2RO
Membrane is clogged
2. The flow restrictor
is inoperative
1. Carbon Block Filter
is exhausted
2. Newly replaced
Carbon Block Filter is not
flushed completely
3. E2RO Membrane filter
is exhausted
4. Water has been sitting in
the tank for too long
Dissolved air in incoming
water supply
1. Tube is not fully inserted
into a connection
2. Filter is not
installed correctly
3. The tip of the tube
is damaged
Solution(s)
See product warranty in last page of manual,
and contact Brondell.
1. See Filter Replacement (page 21).
2. See product warranty in last page of manual,
and contact Brondell.
1. See Filter Replacement (page 21).
2. Open the provided faucet, and drain the water
tank once. Flush one or two tanks of treated water
through the Carbon Block Filter.
3. See Filter Replacement (page 21).
4. Fill and empty the Water Storage Tank two to three
times, and fill again.
Problem should clear up as the condition of the
incoming water changes. Letting water stand will allow
the dissolved air to dissipate.
1. Make sure the tube is at least 1/2-inch into
the connection.
2. Ensure that all three filters are locked into place.
3. Cut the damaged part of the tube, and reconnect
or replace the tube.

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Rc250

Tabla de contenido