Master Trimmers MT Gentle 50 Manual De Uso Y Mantenimiento página 35

Replace the grid back on top and fasten it with the four latches.
7
Replace the container and secure it with the help of the two retaining knobs (G). Finally, connect the container motor cable to the power
8
input located on the side of the machine body.
Disassembling and cleaning the container with agitator
First, press the ON/OFF switches on the machine to turn it off.
1
Then disconnect it from the electricity supply by unplugging
it. IMPORTANT: The machine must be stopped and
disconnected before manipulating it.
Place the container upside down, on a suitable work surface.
3
Proceed with the cleaning/preventive maintenance of the container and the agitator. Once completed, reverse the steps to reassemble
5
the machine.
Loosen the two retaining knobs (G) that fix the container to
2
the body of the machine. Then disconnect the motor cable of
the container from the power input located on the side of the
machine body. Remove the container.
Remove the two M6 domed screws that hold the agitator
4
retaining disc to the motor shaft, using a No. 4 Allen key (P).
www.masterproducts.es
35