Commissioning - geberit AquaClean 8000 Manual Del Usuario

EN
Start-up installation
Start operation of the toilet
An air evacuation routine is performed
automatically the first time the toilet is
switched on.
1
Fit the spray shield.
2
Open the maintenance opening.
1
3
Start the commissioning programme: Press
and hold the button <shower> (1) while
switching on the power switch (2). Wait until
the LED flashes blue.
1
2
The commissioning programme is active as
long as the LED is flashing blue (2–9
minutes).
If the LED flashes red, the malfunction (e.g.
lack of water) must be rectified and the
commissioning programme must be
restarted.
4
Cover the window of the user detection with
your hand and keep it covered.
10
1
2
2
5
Press the button <shower>: The spray arm
extends and the shower spray starts. Adjust
the spray intensity with the <spray intensity
regulator> ("+" more, "-" less).
6
Wait for 3 minutes and check the shower
water temperature.
ºC
7
Remove the spray shield and hand it over to
the customer for later use.
Handing over the toilet to the customer,
ready for operation
1
Explain the main functions of the toilet to the
customer.
Refer to the operating instructions for
detailed information.
2
Hand over end-user documentation to the
customer.
3
Fill in the warranty card together with the
customer (end-user documentation), attach
the serial number sticker and send it to
Geberit.
s s
0 0 p lu p lu
0
a n 8 0 8 0 0 0
n n
le a
q u a C u a C le
ri t A q
t A A
G e b e e b e e ri
G
t u n g g g
n
u u
t t
a n l e i i
l e
a n a n
K u r z z
r
u
K K
4
Attach a second serial number sticker, for
example to the last page of the operating
instructions, so it is available for later use.
B882-007 © 10-2013
996.626.00.0 (07)