Initial Commissioning - geberit 180.100.10.1 Manual De Instalación

Start-up installation
An automatic initiation programme is run before inserting
or filling the active carbon filter and nozzle cleaning agent.
Duration of the programme 2–9 minutes.
Start operation of the toilet
1
Fit the spray shield.
2
Open the maintenance opening.
1
2
3
Press and hold the main button (1) while switching
on the main switch (2). Wait until the dryer arm is
extended and the blue LED flashes. Initiation
programme starts.
1
2
The initiation programme is active as long as the
blue LED flashes. If a fault occurs, the programme
is cancelled after 9 minutes and the red LED
flashes.
If the red LED flashes, the fault (e.g. lack of water)
must be rectified and the initiation programme
must be restarted.
4
Check whether the initiation programme has run
completely (blue LED lights up).
5
Insert the active carbon filter.
1
2
6
Remove the screw cap of the nozzle cleaning agent
and pull out the filling tray on the toilet. Lift the
bottle and turn it around. The nozzle cleaning agent
automatically flows into the tank. Do not squeeze
the bottle, as the nozzle cleaning agent could spray
outside the tank.
7
Reinsert the filling tray and close the maintenance
opening.
If active carbon filter and nozzle cleaning agent are
not used/topped up, the red LED will light up.
8
Cover the window of the user detection with your
hand and keep it covered.
1
3
2
EN
11