Mutsy ICON Manual De Instrucciones página 29

Tip! The push bar height adjustment buttons do not need to be operated
to pull the push bar up.
Adjust the leg support (t2)
· Lift the leg rest to raise it.
· Press the buttons on either side of the leg rest and push the leg rest
down to lower it.
· The leg rest has an integrated foot rest. Unzip the panel on the front of the
foot rest, unfold the foot rest and press the panel back to use the foot rest.
Attach and remove bumper bar (t1)
· Press the ends of the bumper bar into the appropriate recesses on the
seat until a click can be heard when the bumper bar is secure.
· Press the release buttons on both sides of the bumper bar to remove
the bumper bar from the seat.
The canopy (u)
· Grip the front canopy bar in the centre and move it forwards or
backwards to adjust the canopy.
· Open the zipper in the centre of the open canopy to expand the
canopy. Close the zipper to reduce the canopy again.
Fitting the rain cover on the pushchair seat
· Ensure that the pushchair seat cover is in the upright position.
· Open the zipper in the rain cover to allow it to fit into the expanded
canopy of the pushchair seat.
· Place the rain cover from top to bottom over the pushchair seat and
ensure that the rain cover falls behind the backrest and over the leg
rest.
The 5-point safety harness (v, w)
· Place your child on the pushchair seat and ensure that your child's legs
are positioned on each side of the padded crotch strap.
· Make sure that the hip and shoulder belt is positioned correctly over
your child and place both plastic inserts in the central part of the
harness attached to the padded crotch strap.
· To adjust the length of the shoulder straps, loosen the shoulder
protectors from the belt by undoing the Velcro. This will reveal the belt
buckles. Adjust the length by sliding the buckles along both shoulder
straps until your child is comfortably secure. After adjusting, press down
the Velcro on both sides to relock the shoulder protectors in place.
· The backrest contains three positions for the shoulder belts. To adjust
EN
23