Preparations - Panasonic NR-BS53VX3 Instrucciones De Operación

Preparations

Maintenance
Remove all the packing materials and tapes.
Wipe the inside of the refrigerator using a soft cloth which has been dipped in lukewarm water and then wrung out.
Wash and completely dry the icebox before installing it. (Do not use a dish dryer, hair dryer or other appliance when drying.)
Connecting the power plug to the power outlet
When the power plug is connected to the power outlet, the temperature display starts flashing as shown in the figure
on the right, and cooling starts inside the refrigerator.
The temperatures displayed at this time are not the actual temperatures.
When the temperature of the fridge reaches 8 °C, the freezer reaches -12 °C and the Vitamin-Safe Zone reaches
5 °C, the temperature display stops flashing and lights, and it shows the actual temperature.
It takes about half a day to reach the set temperatures (when the room temperature is around 32 °C, there is no
food inside the refrigerator, and the doors are closed).
Place the food inside the refrigerator only after it was confirmed that the refrigerator compartment had been cooled.
Notes:
● Cooling may take longer in the summer months or at other times when the room temperature is higher.
● While the temperature display is flashing, the alarm sounds to warn that the temperature has risen. The alarm can be turned off by
pressing .
● If you need to unplug the refrigerator, wait at least 10 minutes before you plug it back in again. You might damage the compressor.
The Ice/Water dispenser and automatic ice maker
Ice must first be made by the automatic ice maker before the Ice/Water dispenser can start dispensing ice. The automatic ice maker can
make six cubes of ice at a time and about 42 cubes of ice a day (although this will differ depending on the prevailing conditions).
When using the ice maker for the first time, it takes about 8 hours for ice to be made.
Automatic ice-making stops as soon as the icebox becomes full.
Note:
● When using the Ice/Water dispenser and automatic ice maker for the first time, the water or ice may be discoloured or smell: this
is normal and not indicative of any trouble. When water goes around through the water filter and pipes and other parts inside the
refrigerator, these symptoms will disappear so keep supplying the water and removing the ice from Ice/Water dispenser until the
discolouration/smell dissipates.
In some homes, this procedure may have to be repeated a number of times.
How to remove the icebox
● Raise the icebox slightly, and pull the bottom part out toward you. (fig 1)
How to set the icebox
● First align its top part with the automatic ice maker, then push down its bottom part and
insert it firmly into place below as far as it will go.
● Be sure to hold the icebox with both hands.
● Be sure to confirm that the icebox has been set firmly when installing.
(Fall of icebox may cause injury or trouble.)
CAUTION
When the icebox can not be installed correctly
● Insert the icebox to the original position completely after rotating the knob 90 degrees
which located in the back of icebox as indicated in fig 2.
Installation
fig 1
a
b
fig 2
11