Broan Elite E55000 Manual Del Usuario página 10

INSTALL FLUE MOUNTING
BRACKET
DUCTED AND NON-DUCTED HOODS
1. Assemble the flue mounting bracket,
adjusting outside width as shown. Fig.8
2. Carefully center the mounting bracket
directly over the range hood location.
3. Secure the bracket assembly to the ceiling
using (2) 4.8x38mm mounting screws
and drywall anchors (Fig. 9). Make sure
the bracket is pushed into the corner,
tight against the wall and centered over
the hood.
PREPARE THE HOOD
Note: On stainless steel hoods, carefully remove the plastic protective film
from all exterior surfaces of the hood and decorative flues, prior to final
installation.
DUCTED CONFIGURATION
1. Remove the tape on the electrical system plate; place the electrical system plate
on the hood (use a protection). Fig. 10
2. Install the discharge collar into the duct connector of the range hood. Fig. 11
ELECTRICAL SYSTEM
PLATE
PROTECTION
DISCHARGE
CONNECTOR
FIG.10
- 10 -
FLUE MOUNTING BRACKET
3.9 x 6 mm FLAT HEAD
BRACKET SCREWS
10-5/8"
(270 mm)
DRYWALL ANCHORS
4.8x38mm
MOUNTING SCREWS
COLLAR
DUCT
FIG. 8
FIG. 9
FIG.11