Kohler K-8807 Guia De Instalacion página 3

Strainer Plate
Plumbers Putty
1. Install the Strainer
Apply a ring of plumbers putty or other sealant to the underside
edge of the drain body flange or strainer body flange.
Insert the drain or strainer body in the sink.
Assemble a gasket, plate, and nut to the drain body from under
the sink.
Wrench tighten.
NOTE: Do not reposition the drain after the locknut has been
tightened.
Align the wide end of the tailpiece with the drain or strainer
body, slide the nut onto the tailpiece, and thread the nut to the
drain or strainer body.
Position the trap on the end of the tailpiece.
If necessary, cut the tailpiece to ensure proper fit.
Securely tighten the nut.
Insert strainer plate into strainer.
Kohler Co.
Body
Gasket
Plate
Nut
Washer
Tailpiece
Nut
3 112446-2-BD