Troubleshooting - Scheppach HL760L Traducción Del Manual De Instrucciones Origina

You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equip-
ment or your waste disposal company.

17. Troubleshooting

The table below contains a list of error symptoms and explains what you can do to solve the problem if your tool
fails to work properly. If the problem persists after working through the list, please contact your nearest service
workshop.
Problem
Motor stops starting
Fails to split logs
Log pusher moves jerkily, taking
unfamiliar noise or vibrating a lot
Oil leaks around the cylinder ram or
from other points
30 | GB
Possible Cause
Overload protection device disengaged to
protect the log splitter from being damaged
Log is improperly positioned
Size of log exceeds the capacity of the
machine
Wedge cutting edge is blunt
Oil leaks
Lack of hydraulic oil and excessive air in the
hydraulic system
Air sealed in hydraulic system while operating
Bleed screw is not tightened before moving
the log splitter
Oil drain screw loose
Hydraulic control valve assembly and/or seal
(s) worn
www.scheppach.com
Remedy
Contact a qualified
Electrician.
Refer to "operation"
section to perfect log
loading
Reduce log size
before operating
Sharpen cutting edge
Locate leak(s) and
contact your dealer
Check oil level for
possible refilling.
Contact your dealer
Loosen bleed screw
by some rotations
before operating the
log splitter
Tighten bleed screw
up before moving the
log splitter
Tighten the oil drain
screw firmly
Contact your dealer