Package Contents; Electrical Safety - DeWalt DCD920 Traducido De Las Instrucciones Originales

EN GLI SH
Battery charged.
Battery defective.
Hot/cold pack delay.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Use only with D WALT battery packs;
E
others may burst, causing personal injury
and damage.
Do not expose to water.
Have defective cords replaced
immediately.
Charge only between 4 °C and 40 °C.
Discard the battery pack with due care for
the environment.
Do not incinerate the battery pack
(NiMH, NiCd+ and Li-Ion).
Charges NiMH and NiCd
battery packs.
Charges Li-Ion battery packs.
See Technical Data for charging time.

Package Contents

The package contains:
1 cordless percussion drill
(DCD945, DCD935, DCD925 models)
1 cordless midhandle drill driver
(DCD940, DCD930, DCD920 models)
1 Li-Ion battery pack (L1 models)
2 Li-Ion battery packs (L2 models)
2 NiMH battery packs (B2 models)
3 NiMH battery packs (B3 models)
1 Kitbox
40
1 Charger
1 Side handle
1 Instruction manual
1 Exploded drawing
NOTE: Battery packs and chargers are not included
with N-models.
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1, 2)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Trigger switch
b. Forward/reverse button
c. LED light
d. Chuck
e. Torque adjustment collar
f. Mode control collar
g. Gear shifter
h. Side handle
i. Main handle
j. Battery pack
k. Battery release buttons
l. Charger
INTENDED USE
These drills/drivers/hammerdrills are designed
for professional drilling, percussion drilling and
screwdriving applications.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
These drills/drivers/hammerdrills are professional
power tools. DO NOT let children come into
contact with the tool. Supervision is required when
inexperienced operators use this tool.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.