Atlantic NIRVANA Manual De Utilización E Instalación página 6

The product you have just purchased has undergone numerous tests and inspections to guarantee the highest quality.
Thank you for your choice and your confidence in us. We hope it will give you entire satisfaction.
Some recommendations
Please read the documentation before starting to install the panel heater.
Disconnect power before working on the panel heater.
Conserve the documentation, even after installation of the panel heater.
Equipment specification :
IP24 : equipped protected from water splashes
Class II : double insulation.
: appliance in accordance with the European Directive 2002/96/CE (DEEE)
1) Where to install the panel heater ? 1 1 1 1 1 2 2 2 2 2
- This equipment was designed to be installed in a residence. Please ask
your distributor before using it for any other purpose.
- The panel heater should be installed according to normal trade
practice and in compliance with legislation in the relevant country (the
IEE Wiring Regulations).
- The device is to be installed so that switches and other controls
cannot be touched by a person in the bath or shower, except in the UK
where IEE Regulations 701.512.2 and 701.512.3 apply. These allow
the use of IP24 rated products and their integral controls in Zone 2 and
outside zones.
- Comply with the minimum clearance distances as indicated in diagram
2 for positioning of the panel heater.
- If your wall covering is laid on foam, a spacer the same thickness
as the foam must be placed under the panel heater's support. This
ensures there is free space behind the panel heater to make sure its
control settings are not adversely affected.
- Do not install the panel heater:
In a draught likely to affect the control settings (under a
fan, etc.).
Under a fixed mains power socket.
In volume 1 of bathrooms.
If the panel heater is installed at altitude the air discharge temperature will be increased
(by approximately 10°C per 1000 m of altitude).
2) How to install the panel heater ?
2-1) Mount the wall support
- Place the attachment lug on the floor.
- Mark the holes, to determine the position of the lower attachments.
- Raise the attachment lug, making the previously marked holes
coincide so that you can locate the remaining two holes.
- Drill holes and put the inserts into place
- Fix the support.
Note : Do not use the device in mobile or feets or on casters.(diagram 3bis)
(indicated on the label of the device):
INSTALLATION OF THE PANEL HEATER
3 3 3 3 3
.1
3 3 3 3 3
.2
1 1 1 1 1
2 2 2 2 2
3 3 3 3 3