Atlantic NIRVANA Manual De Utilización E Instalación página 9

- There is no point in setting the unit to its maximum, the room temperature will not rise any faster.
- Switch the unit off by putting cursor
- Remember to lower the temperature f you go out for several hours.
If go out for : less than 2 hours, do not touch the controls.
from 2 hours to 24 hours, set the cursor
for more than 2 hours or during the summer, put the unit in Frost Free mode (
If you have several units in the room, let them all operate at the same time, this will give a more uniform temperature
without increasing electricity consumption.
Children must not lean on the appliance. Under certain circumstances, there is a risk that its surface
may cause burns to the skin of young children. If there is any risk of this at all, install a protection
grill.
This device is not intended for use by persons (including children) with physical, sensory or mental
disability, or by persons lacking experience or knowledge, unless they have received from a person
in charge of their safety adequate supervision or preliminary instructions on how to use the device.
Care must be taken at all times to keep children from playing with the device.
Do not introduce objects or paper into the device
Do not totally or partially block the back part of the panel heater, as this may cause overheating.
If the supply cord is damaged, it must be replaced by a service agent or similarly qualified person in order
to avoid a hazard (applies to units fitted with a supply cord and plug).
Units fitted with a three core supply cord (brown, blue & black), must be directly connected to fixed wiring
by a licensed electrician.
All work on the interior of the appliance must be carried out by a licensed electrician.
To maintain performances of your unit, you should clean the entries and exits of air about twice a year using a vacuum
cleaner or a brush. Have a professional check the inside of the unit every five years. The unit casing should be
cleaned with a damp cloth, never use abrasive products.
The unit does not heat :
Check that the programmer is in COMFORT mode.
Make sure that the installation circuit breakers are switched on, or that the load shedder (if you have one) has not
switched off the unit power supply. Check the air temperature in the room.
The unit does not carry out programming orders :
Make sure that the programming unit is being correctly used (refer to its user's manual) or that the K7 Program
is properly inserted in its housing and that it is operating normally (batteries?).
The unit is permanently heating :
Make sure that it is not in a draft and that the temperature setting has not been changed.
This unit with electronic control is equipped with a microprocessor that can be disturbed by some severe mains voltage
disturbances (outside EC standards defining the disturbance protection level).
If there are any problems (thermostat blocked, etc.) switch off the unit power supply (fuse, circuit breaker, etc.)
for about 10 minutes to allow the unit to start again.
Have your energy distributor check your power supply if the phenomenon occurs frequently.
RECOMMANDATIONS FOR USE
to .
WARNINGS
MAINTENANCE
TROUBLE-SHOOTING
to .
).