Tabla de contenido
Publicidad
UCC T3 installation guide
www.renishaw.com
UCC T3 start-up process
When powered on, a self-test and initialisation is performed.
USB comms
If any of the tests fail, the failure mode is indicated on the status LEDs after about 15 seconds. When power cycling, a minimum of 10 seconds
is recommended between power removal and reconnection.
After the UCC T3 has completed its self-test, the system is ready for the software to be downloaded. The sequence of the status LEDs is shown
below.
USB comms active
X
Issued 04 2019
Servo status
Probe seated
Servo status
Probe seated
Error
Error
X
Description
No power to UCC T3
Power applied to UCC T3
Waiting for download
Description
Waiting for download
Downloading, USB data
being passed
Download successful
20
Publicidad
Tabla de contenido
