Renishaw UCC T3 Guia De Instalacion página 35

UCC T3 installation guide
www.renishaw.com
PICS connector
The PICS connector can either be:
Connected directly to the probe – in this configuration the UCC T3 will operate as the probe interface.
Connected to a probe interface (PI 200-3) - in this configuration the UCC T3 will accept the trigger signals from the unit.
The connector is a 9-pin D socket, pinout as follows:
Pin number
1
2
3
4
5
Issued 04 2019
Function
PICS STOP
PICS probe power off (PPOFF)
0 V
PICS LED anode
Probe signal
PICS connector - view of face of socket (rear of plug)
Pin number
6
7
8
9
Shell
Function
Reserved
PICS probe damping (PDAMP)
PICS LED off (LEDOFF)
Probe common
Screen
35